plumber and heating engineer
Radiator replacement
A new radiator suited to the room and connected correctly.
Personally assessed and carefully completed
I remove the existing radiator, check the connection points, and fit the new one in a suitable position. After installation I fill and bleed the system where needed and check the connections before leaving the work area clean.

- I check whether the new radiator's output suits the room
- I check the existing connection points for compatibility
- I remove the old radiator neatly, without mess
- I fit the new radiator securely and level
- I fill and bleed the system after installation
- I check every connection for leaks before leaving the work area
Common mistakes
Choosing a radiator on looks alone
A radiator that's undersized for the room means it never quite gets warm, even with the newest boiler.
Not checking connection dimensions beforehand
Not every radiator fits the existing pipework as-is. Checking this avoids surprises during installation.
Not bleeding the system properly afterwards
Air in the system causes ticking pipes and radiators that stay cold at the bottom.
Frequently asked questions
Does a new radiator need the same output as the old one?+
Not always, sometimes a more efficient radiator gives the same comfort. I work this out for you.
Does the whole system need draining?+
Usually not, I work as locally as possible around the radiator in question.
Can I have a designer radiator fitted?+
Yes, as long as the connections and output check out, a designer radiator is usually straightforward.
Would you like to discuss a heating or plumbing job?
Call Alex or send a WhatsApp message with a short explanation and, if helpful, a few clear photos.